24" Stainless Braided Hose -3AN Female Both Ends, 1pcInline Tubes Power Braid hoses are stocked in a variety of lengths and fitting types for a range of applications and can be customized in length for any drum or disc brake application. They are strengthened first with a Teflon core, then a Kevlar braid, then an elastomer barrier, and finally the stainless steel braid all of which is contained within a rubber housing. This assembly includes a 24 hose with 3AN female fittings on each end. Please Note:

This factory-style hold-off valve is intended for 1970 GM A-

1/8" to -3AN Elbow - Stainless

This factory-style rubber boot seals the master cylinder to the firewall while holding the push rod in place

This clip kit includes all clips necessary to secure all the fuel lines to the chassis of the car: three double snap-in clips

This assembly includes a 10” hose with -3AN female fittings on each end

We also offer 25’ coils of tubing under the [tubing category]

and flaring

·         Vapor emission line – runs from purge valve to vapor canister

This kit connects booster check valve to hard vacuum line

These preformed brake lines will replace the lines that are on the rear axle housing/trailing arms on your vehicle and run from hose to hose or hose to wheel

1968-77 Olds Cutlass A/C Engine Compressor Belt Shield 1pc

·         Adjustable proportioning valve