Limits and fits for engineering - Guide to the selection of fits in BS 1916-1BS 1916 2: 2009 Limits and fits for engineering. Guide to the selection of fits in BS 1916 1 BS 1916 2 gives guidance on the selection of fits given in BS 1916 1. The recommendations apply, in particular, to fits between cylindrical parts, designated as holes and shafts, in which case the term size refers to the diameter of the mating parts. The recommendations are also applicable to parts other than cylindrical, in which case the term size refers to

This European Standard does not apply to surface boxes or to floor and roof gullies in buildings which are specified in BS EN 1253

Alarm systems

parents/carers will have confidence in the ability of the access control system to:

Contents of BS EN ISO 8185:

Transport/traffic engineers

With obedience and compliance to BS EN 527-3

Product designer

This European Standard specifies requirements and test methods for non-electrical disable devices for CO2

Scale effect on disc friction loss

Planning and design of products applying to this European Standard should consider the environmental impact from the product during its life cycle

BS EN 12162 requirements are included for applying a hydrostatic test at different pressures to separate zones within a pump which are subject to different allowable maximum working pressures

sporicidal and fungicidal activity of chemical disinfectants and antiseptics necessitate the use of test organisms whose purity and identity have been verified and whose biological behaviour remains stable