Aluminium and aluminium alloys. Sheet, strip and plate - Tolerances on shape and dimensions for cold-rolled productsBS EN 485 4: 1994 specifies the tolerances on shape and dimensions for wrought aluminium and aluminium alloy sheet, strip and plate obtained by cold rolling, for general engineering applications. It applies to products with a thickness over 0,20 mm up to and including 50 mm. BS EN 485 4: 1994 does not apply to semi finished rolled products in coiled form to be subjected to further rolling (reroll stock) or to special products such as corrugated,

BS EN 1176-11:2008 Playground equipment and surfacing

The requirements for the frames/mountings to which they are intended to be fitted are given in BS EN 175

An automatic protection to the consumer (using a switch to tightened inspection or discontinuation of sampling inspection) should a deterioration in quality be detected

Who is ISO 21940‑1- Rotor balancing of machines for

BS EN 1998-5 covers the design of different foundation systems

BS EN 45558 is horizontal in nature

f)       The text has been editorially revised and the normative references updated

It has been revised to align with current best practice

It also gives guidelines for functions needed in a substation gateway device

6 Primary storage tanks

BS 7985 is particularly useful to:

Multicore and symmetrical pair/quad cables are a type of cable that combines multiple signals or power feeds into a single jacketed cable