Standard Test Method for Determination of Intrinsic Stability of Asphaltene-Containing Residues, Heavy Fuel Oils, and Crude Oils (n-Heptane Phase Separation; Optical Detection)

and where possible

collimated or divergent fields

The requirements of this document do not apply to medical electrical equipment specified in IEC 60601-1 [1] 1 and in vitro diagnostic (IVD) medical equipment specified in IEC 61010-2-101 [2]

Many available solvents that could be used are either not sufficiently active

and accurate alignment of bolt holes with the swivel flange in heat resisting steel

you can be ensured of design characteristics

to achieve corrosion resistance for the pertinent service conditions

The checking method will assist you in calculating the load so that the bush's outside diameter is reduced only elastically during testing to ensure that there is no permanent deformation

The conditions used in the test described in BS EN 13016-3 are a vapour-to-liquid ratio of 4:1 and a test temperature of 37

— requirements for mobility support in Future Network

It refers to a packet-switched cellular network technology specified by 3GPP

What is BS EN 13596 - waterproofing of concrete bridge decks about