Shrink chuck 4,5° SK 40 - 12 - 160Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance1 For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Clamping capacity up to –0

Setting angle: 107

For the transfer of a defined torque

SK 30 without coolant exit bores on the end faceDelivery:

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance3

and other hard to reach portions

driving ring and feather key

T-nuts 18 mmTest certificate

Metal housing with rotating lever gauge

Construction: Hardened steel

bei Ø 6 – Ø 32 mm = h238

Coolant pressure up to 100 bar