Combi shell mill holder SK 40 - 22 - 100Application: For mounting milling cutters with transverse or longitudinal groove. Delivery: With retaining screw, driving ring and feather key All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

low warpage hardened

If your 3D probe is nevertheless damaged by external force

bei Ø 6 – Ø 32 mm = h237

Through hole for internal cooling provided

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance6

A complete certificate of calibration traceable to the N

Resolution: 30"/0

For mounting straight-shank tools in 2 µm-collets

Extremely strong holding force (increases the holding power by at least 60% compared to standard ER chuck)

- Higher repeat-accuracy

which can cause high frictional forces on the thread flanks

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance