DRIVE SHOWER BRAVO III FLEXThese drive showers are available for Bravo and Alpha drives and are ideal for use on applications where added clearance is needed for external steering systems.

These vents are 23 1/2" x 3 7/8" and accept one of our billet grab rails (275-30)

This is the cooler all others try to imitate but can never duplicate

USCG approved

Oildyne Trim Pump

These caps are commonly used when switching to a thru-hull exhaust system when the y-pipe is no longer needed to route the exhaust

These units use the same mounting holes as the traditional handles and vents so they are perfect for a new boat building project or they will retro-fit the traditional handles and vents

when installing on ANY Integrated Transom Assembly (ITS) Caution must be used to make sure the trim limit switches are adjusted to the point to eliminate any potential interference between the drive shower cap and the ITS cover

Fabricated out of stainless steel

5" tip/tails

1-1/4" NPT inlets and outlets

Cover Only

3/8" NPT Oil Connections