WATERING CAN DIE- GINA MARIE DESIGNSTIPS AND TRICKS FOR DIE CUTTING When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a better cut using this trick! Plate dies and

That means you could need to shim or use a precision plate and that there will be LOTS of little pieces

Colorful card design shows the cut out pieces put back into the main part of the die

The largest oval measures approximately 4

65 tall/wide

Largest approx 5

The splash line tree

25 (cuts just a smidge under

Measurements

We have carefully hand packaged all letters into a little pouch

These new wonky shapes have an EXTRA FEATURE

Slightly decorative font

Made in the USA