Tools for moulding. Shouldered ejector pins1 Scope This International Standard specifies the dimensions and tolerances, in millimetres, of shouldered ejector pins with cylindrical head which are used in compression and injection moulds and in die casting dies. It also gives material guidelines and hardness requirements, and specifies the designation of shouldered ejector pins. Ejector pins with cylindrical head are specified in ISO 6751; flat ejector pins are specified in ISO 8693.

and the interpretation of results are not specified in ISO 4536

This document specifies an analytical method

Contents of BS EN 60335-2-17:

Where IEC standards do not exist for the transformers mentioned above or for other special transformers

and resonator gases

generally in the microwave and millimetre wave bands

or by tutors or other human intervention

e) identify other clauses in EN 206 where CEN Member Countries have amended or added to the requirements

Fire test certificates of valves previously tested according to previous editions of BS EN ISO 10497 and to similar internationally recognized fire test standards are also acceptable

The clamping force for a complete rail fastening assembly is determined by measuring the force necessary to separate the rail from the surface on which it is supported

are not considered

BS EN 60371-3-5 series is a specification for individual materials that deal with the insulating materials built up from mica splitting or mica paper with or without reinforcement and with mica paper in its pure state for use in electrical equipment