Katana Preset Footswitch v2The Kat Preset Footswitch is designed to be used with the Boss KATANA 50, KATANA 100, KATANA 100 212 and KATANA Head MKI and MKII amps that have firmware 2 onward. The footswitch let you switch between the amp presets 1A, 1B, 2A and 2B. A TRS cable is required to connect the footswitch to the CH1 CH2 foot control socket on the rear on the amp, you can add a Bright Onion TRS cable to the order above, the cables are built using Van Damme cable and

Compatible with - TC Electronics Flashback 2

The pedal can be used with the Eventide H9

The pedal comes with the added benefits of being active and having the second and third outputs going via isolation transformers

The 2 gang patchbox has a top to top socket layout and is totally passive so no power required

Walrus Audio and more

This pedal is a dual latching footswitch for Marshall amps that take a dual 1/4" footswitch with LEDs

The Kat Preset Footswitch is designed to be used with the Boss KATANA-50

Relay signal switching

How to set up your HX Stomp to work with the HXFS Stomp Footswitch

and the Bypass switch cuts out the selected loop leaving your clean tone

Boss 500 Series pedals

1mm 9v DC Socket (centre negative) and internal battery holder