Testing hardened concrete - Determination of creep of concrete in compression1 Scope This document describes the procedure for determining the creep (total creep, basic creep and drying creep) of hardened concrete test specimens subjected to a sustained longitudinal compressive load. The test is suitable for specimens having a declared value of D of the coarsest fraction of aggregates actually used in the concrete (Dmax) not greater than 32 mm.

This document does not apply to interpreting services

The tests can be described as tensile tests at relatively high strain rates

Accelerated test of light fastness of coloured anodic oxidation coatings using artificial light

Output measurement for heating capacity of air-to-water and air-to-air units

The premises-specific cabling standards of the EN 50173 series reference the D1 requirements of this specification for the cable used within cords of the “reference implementations” of those standards

Why should you use BS 7118-2- Flow measurement devices

modifying setting time and increasing overall concrete strength

1) for normal use

fitness for purpose

equipment supply

The full and transparent implementation of each process constitutes the basis for the electoral body to achieve legitimacy

Provision of service