Grooved pins. Full-length parallel grooved, with chamfer1 Scope This International Standard specifies the characteristics of full length parallel grooved pins made of steel or austenitic stainless steel with chamfer which have three equally spaced grooves impressed longitudinally on their exterior surface and a pilot to facilitate insertion, with nominal diameter, d1, from 1,5 mm to 25 mm inclusive. The displaced material to each side of the grooves forming an expanded diameter d2 which is larger than the

2 - Flame atomic absorption spectrometric methods for the determination of the vanadium content of iron ores about

and environmental performance requirements

giving an assurance of quality to purchasers of “off-the-shelf” assessment software

Safety certification providing entities for electro-sensitive protective equipment

Cleanrooms consume large amounts of energy compared to non-classified rooms – as much as 25 times more

EN 14175-4 applies

if the actual impedance of the supply at the supply terminals of equipment connected within the equipment user’s installation exceeds the test impedance

Supplier’s declaration of conformity

Why should you use BS EN 13203-2

qualification testing or certification testing of the cabling

Why should you use ISO 665

This European Standard specifies the requirements and test methods for the construction