Electricity metering equipment (a.c.). Acceptance inspection - General acceptance inspection methodsBS EN 62058 11: 2010 Electricity metering equipment (a. c.). Acceptance inspection. General acceptance inspection methods The general acceptance inspection methods specified in BS EN 62058 11 apply to newly manufactured electricity meters produced and supplied in lots of 50 and above. BS EN 62058 11 can be used for assessment of conformity with the requirements of the Directive 2004 22 EC of the European Parliament and of the Council on measuring

ISO 10005 on guidelines for the quality plans are useful for:

you can be ensured of quality assurance requirements for sensor-based clamp load measurement systems

including the bend radius and amount of fibre that is bent

This standard will be important to anyone responsible for the safe use and operation of MEWPs

Programme Management is typically concerned with activities at a much higher level

End connections

Change in definitions of berthing mode and navigation conditions

may disconnect the gas supply to the consumer’s premises

6 Message Delivery Order

the document presents direction concerning control technologies

BS EN 14701 is the fourth part of an international multi-series standard that discusses the characterization of sludges for filtration properties

6 Overpressure test