1200 Watt Diversion Dump Load (4 Resistor Bank)This divert load resistor is for use to divert the excess power being generated when your wind turbine generator batteries are full and can be ran at 100% duty cycle due to the quality rib wound design. It can also be used with a solar array in diversion mode. Diversion dump loads are very important to have with a wind turbine to keep it from free spinning. The unit can be used alone to provide free heat as well by hooking your solar panels directly

PowerAssist - Boosting the capacity of shore or generator power

with strength and efficiency that dominates fuel-powered generators

Power your pond aeration with just solar and our DC pump

The benefit: More power into your batteries before and after peak hours

If the battery is below <35°F (<2°C)

and 48 volt models

They are rated to withstand 125 mph winds and are designed to operate real PMAs (permanent magnet alternators) at high speed in low winds to create the maximum power a PMA can put out

Shipping L x W x H: 18 x 12 x 6 inches

DO NOT USE GRID POWER AS IT WILL IMMEDIATELY DESTROY THE ELEMENT

Prolong the life of your Legacy PMG by protecting it from the effects of saltwater environments

High voltage re engage: 135V +/-4%

Dimensions (LxWxH): 7