Arduino Light Sensor (LDR) Breakout For Arduino Z6323The light sensor module provides an analog output for measuring and triggering dependant on surround light level. All you need to connect it to your Arduino or compatible board is GND, 5V, and one analog input. On a 3. 3V microcontroller VCC should be connected to 3. 3V instead of 5V. Accepts any power source (VCC) between 3. 0 and 5. 5V DC. Output voltage will vary between 0V and slightly less than VCC.

Learn to code

(at 6-gram pressure)

Support for on board applications

Zipper carry case

tap or flick your wrist to control your Raspberry Pi with the Flick HAT

Parasitic Power Mode Requires Only 2 Pins for Operation (DQ and GND)

Housing: Metal

Note: Not suitable for use with S5540 series resettable breakers

Includes small strap

Electrical life: >100

8 Pin RJ45 Male to 8 Pin RJ45 Male Blue 5m - Category 6

Output Current: 2