Guidance on the application of CE marking and preparation of Declaration of Performance for sanitary appliances1 Scope This document is primary a guidance and shows instructions, explanations and examples for preparation of Declarations of Performance as well as for CE marking in accordance with 305 2011 EC. The guidance is expecially intended for harmonized standards of CEN TC 163 e. g. EN 997, EN 12764, EN 13310, EN 13407, EN 14055, EN 14296, EN 14428, EN 14516, EN 14527, EN 14528 and EN 14688. Products covered by these harmonized standards and therefore the

mechanical and atmospheric conditions and to provide a means of comparing test results when the tools used to make the connectors are of different designs or manufacture

The BS 5131 series describes methods of test for footwear and footwear materials

BS EN 660-2 provides properties of a floor covering that you should comply with during designing and production to improve the working life of the friction materials during service

BS 4444 outlines the principles involved in the design and construction of earth monitoring

— the gas function of dual-fuel burners designed to operate simultaneously on gaseous and liquid fuels

If there is a private drinking water supply within the property boundary

during normal operation

inspection and testing tables of insulating glass units

NOTE 2 The use of IHE Audit trail and Node Authentication (ATNA) as well as Consistent Time (CT) is required as part of IHE XDS

power frequency variation

These methods are particularly applicable to the determination of the resistance of PVC to degradation by heat

T- and U-shaped cross-sections which would fit within a circumscribing circle of a maximum 180 mm diameter and to bars with thicknesses from 3 mm up to and including 60 mm and with widths from 6 mm up to and including 120 mm