C133M-35X60 Locking AssemblySingle taper, self centering design without mounting flange for use in through bored components. Mounted component moves axially during installation. View Catalog PageInstallation & Removal Instructions

Provides torque transmission & alignment

Traditional cost effective collar design

Ideal for wash down applications in wet or harsh environments or where sanitary conditions are a factor

non-self-centering design for use in counter-bored components

USDA/FDA approved

self-centering design for use in through-bored components with extremely high torque and/or bending requirements

Collars include stainless steel screws

Extra thick non-conductive rubber liner corrects misalignment up to 2° while reducing noise & vibration

Allows you room to re-bore the ID without damaging the clamp screws

Climax Series C801 Single Nut Locking Assemblies deliver a mechanical interference fit and provides a higher torque capacity over alternative keyed connections

Bearing insert with 2 set screws has longer inner race for added load support

Tolerates -60° to 180° F