Specification for nails - Steel nails1 Scope 1. 1 This part of the standard specifies requirements, including dimensions and finish, for the types of steel nails listed in 1. 1 and 1. 1. 2. NOTE The nearest former s. w. g. numbers are included in a separate column in each table for convenience only. They do not form part of the specification. 1. 1. 1 Wire nails 1) Convex head roofing nails (chisel or diamond points) 2) Pipe nails (chisel point) 3) Hardboard panel pins (round shank) 4)

Conforms to specified requirements

BS EN 997 on WC pans and WC suites with an integral trap is useful for:

metadata entities

it is important for practical and safety reasons to know of the latest electrical installation standards

With an operating pressure (PO) of maximum 50 kpa (0

the range of ambient temperatures

heating and stand-alone power generation in commercial and public sector facilities

The second part of the BS 8895 series is a code of practice which sets out guidance to encourage the construction industry to design for material efficiency

Why should you use ISO/IEC 27001 - Information security management systems

maintenance and use of optical fibre emergency lighting systems

3 Except where stated otherwise

• Lead-acid batteries of the dimensions according to EN 50342-2 for vehicles with the capability to automatically switch off the ICE during vehicle operation either in standstill or moving (“StartStop”)