YAMAHA KT100 IGNITION TCI MODULE HOLDER BY TRU TESTGO KART YAMAHA KT100 IGNITION TCI MODULE HOLDER BY TRU TEST I have a limited quantity of these available. Get one now and it will be sent today if you use Paypal to cover the payment. This part is an aftermarket version part. Designed to hold your TCI Ignition box. Also Made to earth the TCI when holding EARS are broken or damaged

2 x 8x60mm countersunk capscrews

Keep your valuable data logging electronics clean and protected

BY ITALSPORT

Go Kart IAME  Foam Air Filter

A standard 19mm Locking Collar in use and compulsory on all Karting Australia registered go karts

You will find that these bearings will meet or exceed your expectations

done the installation

SUPPORT - KZ

FACTORY WITH THE STRICT TEST QUALITY CONTROL

But not efficiently and certainly not with the power output the carburetor is capable of producing

Diameter - 10mm or 8MM

This prevents an out of round situation when just two grub screws are both tightened up onto one side of a quality 50mm ground thin wall axle