Geometrical product specifications (GPS). Wedges - Dimensioning and tolerancing1 Scope This part of ISO 2538 specifies methods for the dimensioning and tolerancing of wedges. NOTE For simplicity, only truncated wedges have been represented in this part of ISO 2538; however, this document can be applied to any type of wedge.

concentrations

BS EN 1737 on prefabricated concrete out-of-plane joint strength is useful for:

What is BS EN 2786 - Electrolytic silver plating of fasteners about

up-to-date information from authoritative sources

The term “man-made fibres”

The guidelines in BS EN 60512-8-1 help you assess the static load tolerance of connectors for electronic equipment that enable you to provide a superior quality product to your customers

ISO 11413 provides the conditions for the preparation of pipes and fittings

Zn (asterisk indicates a possible lower recovery compared to aqua regia digestion method specified in ISO 15587‑1

Contents of BS EN 61290-3:

applicable in England and Wales except inner London

This Part 405 of IEC 60811 specifies the procedure for the thermal stability test which applies to PVC compounds

Surgical equipment (see IEC 61847)