End mill holder Weldon SK 40 - 10 - 100Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

For DCONWS = 60 only with four fixation screws according to DIN 912

Clamping capacity up to –0

E2= 7 pieces

For longitudinal and plane turning

Probing is possible in all axis directions (X/Y/Z) with the same pointer resolution

Search for the neutral point and raise in 3-axis

Setting rings

For targeted cooling and lubrication on the cutting edge/evacuation of chips

Extra large LCD readout

- Calibrating the accuracy of the turret recordings of CNC lathes

right angularity: 0

Accuracy: ±5 min