Plain bearings. Quality control techniques and inspection of geometrical and material quality characteristics1 Scope This International Standard specifies quality control techniques and inspection of the geometrical and material quality characteristics of the following types of plain bearings: thin walled half bearings with or without flange, as specified in ISO 3548; metallic thick walled half bearings (with and without flange) that are manufactured as halves but that are necessarily interchangeable and have the ratio s3 : Do > 0,11; wrapped bushes, as

RFID such as ISO 18000 series)

together with procedures for its operation

The content of non-olefinic monomers with functional groups up to a maximum of 1 % by mass in polybutene-1 has been increased to 3 %

Establish whether BS ISO/IEC 20000-1 applies to your organization’s specific circumstances

Among different air disinfection techniques

BS ISO 10004 Quality management — Customer satisfaction — Guidelines for monitoring and measuring

PD IEC/TR 62921 specifies the product category rules which recommends “state-of-the-art” process and data assumptions in order to reduce uncertainty

This European Standard defines the requirements for moulded elastomer seal elements for use in hydraulic systems using phosphate ester fluids for aerospace application

2 “Safety analysis” has been removed

By organizations- that want to switch from single-system development to SSPL for producing their products

Some significant changes between BS ISO 21940‑1:2019 and BS ISO 19499:2007 are:

The minimum levels (ML) in Table 2 are the levels at which the dioxin-like PCBs can typically be determined with no interferences present