Technical drawings. General principles of presentation - Basic conventions for cuts and sections1 Scope This part of ISO 128 specifies the general principles for presenting cuts and sections applicable to all kinds of technical drawings (mechanical, electrical, architectural, civil engineering, etc.) following the orthographic projection methods specified in ISO 5456 2. For areas on cuts and sections, representation is according to ISO 128 50. Attention has also been given in this part of ISO 128 to the requirements of reproduction, including

structures including their installations and contents as well as people

Forklift manufacturers

3 on compliance test procedures for steady-state availability is useful for:

when moisture is present in excess

post or face-to-face interaction)

and scanning probe tips

It can also detect flaws just below the surface

It is not normally applicable to woven elastic fabrics

it shall ensure a safe transfer of person(s) under dynamic conditions

iron powder materials (including alloys)

see IEC 1010) and does not contain either requirement for protection against environmental conditions or the relevant tests

Annex C - List of possible threat types