Ethernet / USB HUB HAT (B) for Raspberry Pi Series, 1x RJ45, 3x USB 2.0Ethernet USB HUB HAT (B) for Raspberry Pi Series, 1x RJ45, 3x USB 2. 0 The ETH USB HUB HAT (B) is an Ethernet and USB HUB designed for Raspberry Pi, providing 1x RJ45 Ethernet port and 3x USB 2. 0 ports. It's pogo pin design is specialized for Zero series, while the onboard normal USB connector can be used to connect with other Raspberry Pi boards through a USB cable. 3x extended USB ports, compatible with USB 2. 0 1. 1 Incorporates RTL8152B Ethernet

This voltage can easily be read by a multimeter or an analogue to digital converter

By employing two MOSFET transistors

It can be used for a range of applications that rely on human presence detection

SPBTLE-RF product page

reading and writing of NFC forum type 1

25 dBm @ 11 CCK

The CR95HF has 2 operating modes: Wait for Event (WFE) and Active

or PWM - all of which are active at the same time

The signal is processed by a BISS0001 PIR sensor controller which sends an interrupt to the MCU through the mikroBUS INT (out) line

Capture Video with Audio: High frame rates

(2x) Analog Output (0-10Vdc)*

Phidget RFID Read-Write Enclosed 1024_1